| Engine cont. |
After positioning the spider tank where
I wanted it, I was in need of water
hoses with the correct bends. I found
one at AutoZone that was long enough
to work for two and had my bends.
Paid $13...Just try to beat that at
Spruce :>) I plan to buy another one
of these and carry it for emergencies.
I wanted it, I was in need of water
hoses with the correct bends. I found
one at AutoZone that was long enough
to work for two and had my bends.
Paid $13...Just try to beat that at
Spruce :>) I plan to buy another one
of these and carry it for emergencies.
Here is the bracket I made to
secure the coils. The small rubber
mount was used on teh opposite
side bolted through the rear web of
the motor mount. Very stable now
but with just enough flex (at least I
hope so)
secure the coils. The small rubber
mount was used on teh opposite
side bolted through the rear web of
the motor mount. Very stable now
but with just enough flex (at least I
hope so)
Showing the bolt that goes
through the front of the coils
and is attached to the bracket
above.
through the front of the coils
and is attached to the bracket
above.
Showing the back side of the coils
where I bolted that rubber mount to the
web of steel.
where I bolted that rubber mount to the
web of steel.
A shot of the engine so far.