Brake Stuff
Here is the kit.
The time consuming end of the
gig was getting the end of the
line just right. Cutting it was no
problem...just a hammer and a
cold chisel. After the cut, the
stainless wire needed to be cut
back a bit.
This diamond rotary bit used on
the dremel was the ticket for the
clean-up.
Don't tighten too much and
don't ask why I know.
First one done...piece of cake. I
just hope they work as good as
they look.
Most of them done except for the two
short ones that will go to the
reservoir.