| Panel Stuff |
This is a shot of the Phil Laker panel
frame I purchased from Murle Williams.
He had this in his attic of stuff and as
far as I know, there are only a few of
these out there for a model IV.
frame I purchased from Murle Williams.
He had this in his attic of stuff and as
far as I know, there are only a few of
these out there for a model IV.
I went back and forth for a while
thinking I wanted to use a traditional
Kitfox panel. Here you can see I went
as far as cutting one out. This was
thinking I wanted to use an EFIS as
well as all the steam gauges.
thinking I wanted to use a traditional
Kitfox panel. Here you can see I went
as far as cutting one out. This was
thinking I wanted to use an EFIS as
well as all the steam gauges.
After deliberation, I decided to go
with the Laker design. You can see
I am still hanging on to a couple
steam gauges.
with the Laker design. You can see
I am still hanging on to a couple
steam gauges.
Here I have the aluminum cut
into the frame & notice I am
trying to wean myself from the
steam gauges... at least for this
week. <g>
into the frame & notice I am
trying to wean myself from the
steam gauges... at least for this
week. <g>