| Prime Time To Prime |
Several of the aluminum parts were primed with the epoxy primer. Can you identify any of the hanging
parts? The flapperons are laying on the table still wrapped in the nasty plastic coating. I tried using a
paint stripper (as suggested) on it but it wasn't caustic enough. I need to go back to Homer and buy the
paste stripper.
parts? The flapperons are laying on the table still wrapped in the nasty plastic coating. I tried using a
paint stripper (as suggested) on it but it wasn't caustic enough. I need to go back to Homer and buy the
paste stripper.
| Below you can see the Grove Gear in the primed state. I'm glad the painting is almost to a close...my painting booth is falling apart with the extreme heat outside. The AC does a good job of keeping it 20 degrees cooler than outside, but it was 117 degrees yesterday. This allows the duct tape to just melt apart |